Ihr Warenkorb ist leer
Ihr Warenkorb ist leerKunde
Bewertet in Deutschland am 22. August 2021
Super für heimwerker.
Michael
Bewertet in Deutschland am 28. Februar 2019
Gut
Stuart
Bewertet in Großbritannien am 28. April 2019
Absolutely terrible quality. I'd burnt the tip with the first 3 passes over some contiboard
Roger
Bewertet in Großbritannien am 11. April 2016
Was not able to use this product as is marked with max rpm 10,000 and my router min rpm is 12,000. Max rpm should be shown on the website as this affect safety.
Daniele Mancini
Bewertet in Italien am 11. November 2015
I taglienti sono ben affilati e con una lunghezza di 2 pollici, è possibile effettuare delle scanalature molto profonde.L'immagine reale dell'oggetto non è quella inserita nell'annuncio, ma è quella che invio in allegato.Il gambo della fresa è lungo 3,5 cm, diametro 1/2 pollice.
alfred
Bewertet in Deutschland am 3. Juli 2014
Ist sehr schnell stumpf. Professionell gar nicht zu gebrauchen. Schablone und Fräser Finger weg davon. Das ist meine Meinung nach dem kauf und Probelauf.
Mike
Bewertet in Großbritannien am 12. April 2013
No complaints about this bit, low cost but has been used primarily to joint boards through the router table. I doubt it will last as long as a more expensive bit would have cost but considering the price i would say its a bargain
alno33
Bewertet in Großbritannien am 29. September 2012
I have purchased 2 items.One of them was absolutely new but the second have his package open and was used once....
Produktempfehlungen